r
l
M
C
eplaCe
Ift
otor for
Troubleshooting
•
Before replacing the lift motor for couch adjustment
make sure that the motor is actually defective.
•
For this check, switch the hexagon socket of the
liftmotor from channel 2 to channel 1.
•
If the motor does not work, it is out of order and
must be replaced.
•
If the motor works, the motor control unit or the
hand switch is defective.
Follow these steps to replace the couch adjustment motor:
•
Set motor to the end position where the couch
surface is completely horizontal.
•
Disconnect system from mains!
•
When the lift motor has been removed, the couch
surface must be protected against falling down!
•
Disconnect plug of cable M at motor control
(connector 1. in illustration).
Open cable tie and pull cable towards the lift motor.
•
Remove pins b. + c. with self-locking screw.
•
Remove lift motor.
Note:
Reverse the above steps to install the new lift motor.
Secure the connection cable to the motor controlunit with
cable ties.
2018112-069 Rev. F
a
BCu
ouCH
djustMen wItH
eBike II, eBike II L, eBike II EL
1.
- 111 -