r
eplaCe Motor Control unIt
B
loCk dIagraM Motor Control unIt
remote control
r
eplaCe Motor Control unIt
Troubleshooting
•
Before replacing the motor control unit make sure
that the motor is actually defective.
•
For this check, use a new hand switch (the hand
switch for eBike EL can also be used) and test the
motorfunctions.
•
If the control unit does not work, it is out of order
and must be replaced.
•
If it works, the hand switch is defective.
•
Disconnect device from mains!
•
Disconnect all cables prior the disassembling of the
unit, using a suitable fork wrench or the special tool.
2018112-069 Rev. F
motor control
SUB-D
connector
on/off
switch
eBike II, eBike II L, eBike II EL
saddle motor
2
2
motor longitudinal tilting
1
1
power cord
for connector identification:
see „wiring diagrams"
- 103 -