Table of Contents
Advertisement
PROBLEMS - CAUSES – SOLUTIONS
16. PROBLEMS - CAUSES – SOLUTIONS
16.1 Introduction
This section covers potential problems which may occur during machine operation, along with
their causes and solutions.
Should the inconveniences continue or take place frequently even after having carried out all the
instructions stated in this section, please contact Technical Support.
16.2 Problems (P.) - Causes (C.) – Remedy (R.)
P:
Machine does not start:
C.
Circuit breaker has tripped.
R:
Reset the circuit breaker.
C.
Machine switched off.
R:
Press the start button.
P:
Programme does not start:
C.
The door is not correctly closed or locked.
R:
Check door closure.
C.
Lack of process chemicals.
R:
Switch machine off and replace container.
P:
Relevant operating temperature not reached:
C.
The thermostat sensor in the chamber is soiled or covered with limescale.
R:
Clean temperature sensor in chamber.
P:
Cleaning results are unsatisfactory:
C.
The nozzles are clogged by deposits or limescale.
Clean the nozzles by carrying out the routine maintenance described in these
R:
instructions.
C.
Insufficient water for washing enters the chamber.
Ensure that the water is supplied at the correct pressure and that there are no
R:
obstructions to the passage of water.
The correct amount of water required for wash cycle is not delivered to the
C.
chamber.
Shut off the water supply and call in a service technician to clean the inlet filters
R:
(User: SERVICE).
P:
Incorrect dispensing:
C.
Dispenser pump is not working properly.
The routine maintenance is performed by a service technician.
R:
(User: SERVICE)
C.
Dispenser pump failure.
R:
Contact Miele Service or call in a service technician to repair or replace the pump.
REV.0.00_COD.223130_A4
Page 44
Hide quick links:
Advertisement
Table of Contents
