Husqvarna 326 E Workshop Manual page 6

Starter
Assemble the starter handle.
Tension the return spring.
Check the spring tension.
Fit the starter on the engine body.
Do not forget the guide sleeves for the fuel
tank.
First press in the top edge of the starter
under the cylinder cover.
Press in the starter against the engine body
and check that the drive dog engages.
Fit the screws.
502 50 18-01
Assemble the starter handle.
Tie a double knot and fold under the free end.
Pull the knot fully into the handle.
Tension the return spring.
Pull the starter cord out completely and slow
the starter pulley with your thumb.
Lift the cord into the notch on the starter
pulley.
Now turn the starter pulley anticlockwise,
6 turns.
Check the spring tension. With the starter
cord fully extended it should still be possible
to turn the starter pulley further, at least a
half turn.
Fit the starter on the engine body.
1. Check that the rubber bushings are in
position in the starter housing.
2. Insert the top edge of the starter under
the cylinder cover and fold the starter in
against the engine body.
3. Check that rubber bushings in the starter
housing connect against the lips on the
fuel tank.
4. Press the starter in against the engine
body.
5. Pull the starter handle and check that
the drive dog engages.
6. Tighten the screw in the centre of the
starter fi rst followed by the 2 other screws.
1
5