Husqvarna 326 E Workshop Manual page 30

Fuel system
Assembling the carburettor
Blow the carburettor housing clean.
Fit a new plug.
Fit a new main jet.
Assembling the carburettor
• Blow all channels in the carburettor
compartment clean
• Mount a new plug.
Use a suitable punch to get a comple-
tely tight seal.
• Press in a new main jet.
• Mount the valves and dampers.
Tip!
Any numbers on the valves should be able
to be read from the outside.
Replace the fuel screen if it is damaged or
cannot be cleaned.
Place the pump diaphragm closest to
the carburettor housing. Then the gasket
and cover and the other components in
reverse order of removal.
NOTE!
Check that the valves are turned
correctly and that they close
completely and tightly in the closed
position.
Use Loctite on the valve screws.
3
29