Bosch ADS 325 User Manual page 46

en | 4 4 | User Manual | ADS 325
Location
Used to find where specific components are located.
1. Select Location Info from the Diagnostic Information
screen.
ss03198
Connected to 2003 GMC Yukon XL 1500 SLT 5.3L | PCM
Location
Fuse Box Location
Instrument panel fuse boxes are on the right and left side of the
instrument panel - there are two boxes. Underhood fuse box is located on
the left side of engine near the battery.
ECU Location
DLC Location
Component Location
2. Scroll through the list and select the desired compo-
nent.
Brake Bleed Procedure (ABS)
Provides the procedure on how to bleed the brakes after
replacing brake calipers or opening a brake line to atmo-
sphere.
1. Select Brake Bleed Procedure from the Diagnostic
Information screen.
ss03199
Connected to 2003 GMC Yukon XL 1500 SLT 5.3L | PCM
ABS Bleed Procedures
Brake Bleed Sequence: RR, LR, RF, LF
GRAVITY BLEED
0) Refill the brake master cylinder reservoir as necessary.
0) Warning: brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands
thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes.
0) Fill the brake master cylinder reservoir with brake fluid.
0) Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical
2. It may be necessary to change controllers at the
Screen, then re-enter diagnostic information for this
selection to become available (ABS, ABS/VSES).
NOTE: The sequence may be contained within the previous brake
bleed procedure section if it is not separately listed on the Diag-
nostic Information screen.
582819 | REV. A | 07.2018
Tune Up Specifications
Provides specifications for specific components when a
tune up is performed.
1. Select Tune Up Specs from the Diagnostic Informa-
tion screen.
12:35
ss03200
Change Vehicle Home
View User Manual
Tune Up Specs
Injector
Generator
Spark Plug
Fuel Pressure
Compression
2. Some of the tune up specifications contained in this
section include the following:
•
•
•
•
•
•
•
12:36
•
Change Vehicle Home
Key Programming
Displays instructions for the selected vehicle for pro-
gramming a key.
1. Select Key Programming from the Diagnostic Informa-
tion screen.
ss03201
Key Programming
Battery Replacement
Immobilizer
2. Follow the prompts on the screen to program a key
and or replace battery in key.
Connected to 2004 Ford F-150 XL 5.4L | ABS (4WABS)
Specification: 11:0 to 14.0 Ohms
Starter
Generator
Regulator
Spark plug
Idle speed
Fuel pressure
Compression
Firing order
Connected to 2004 Ford F-150 XL 5.4L | ABS (4WABS)
See Image
Bosch Automotive Service Solutions Inc
12:38
Change Vehicle Home
View User Manual
12:38
Change Vehicle Home