Table of Contents
Advertisement
Problem solving guide
With the aid of the following guide, minor problems can be easily corrected
without contacting Miele. If, after reading this guide, you can't remedy the problem
yourself, please call Miele (see back cover for details).
Please note, however, that a call-out charge will be applied to unnecessary service
visits where the problem could have been rectified as described in these operating
instructions.
Danger of injury! Installation, maintenance and repairs may only be carried
out by a suitably qualified and competent person. Repairs and other work by
unqualified persons could be dangerous. Miele cannot be held liable for
unauthorised work. Do not attempt to open the casing of the steam oven
yourself.
Problem
You cannot switch the
appliance on.
The steam oven does
not heat up.
The fan can still be
heard after the
appliance has been
switched off.
A humming sound can
be heard after switching
on the appliance, during
operation and after
switching off the
appliance.
132
Possible cause and remedy
The circuit breaker is defective or has tripped.
Reset or replace the circuit breaker (see data plate
for minimum fuse rating).
There may be a technical fault.
Disconnect the appliance from the mains
connection for approx. 1 minute:
– switch off at the wall socket and withdraw the
plug, or
– switch off the mains circuit breaker.
Reset the trip switch in the mains fuse box, and
switch the appliance back on. If it still will not
switch on, contact a qualified electrician or Miele.
Demo mode is active.
You need to deactivate the Demo mode (see
"Settings - Showroom programme" ).
The fan is still running.
The appliance is fitted with a fan which removes
steam from the oven. The fan will continue to run for
a while after the appliance has been switched off. It
will switch itself off automatically after a while.
This is not a fault. It is made by water being pumped
through the system.
Advertisement
Table of Contents
