Table of Contents
Advertisement
WIT-300H User Manual
Issue: 0.4C
Lock Phone
User can lock the phone. If a user locks the phone, WIT-300H ask the user to enter password on trying to
use it. A user can also change the password for the lock mode here.
Reset Default
It changes sound setting and display settings.
Note:
1. The password is not changed.
[Password Management ]
For new password setting, a user should enter two items; a new password and an asking to be
questioned when he will change the password. When he forgot both of them, he should contact the seller.
6.5.4
Network
This menu provides information on using the network configuration. This menu has 5 sub-menus; DHCP,
Static IP, 802.11b Configuration, Authentifications, and Load Default.
Setting Up DHCP (Dynamic Host Configuration Protocol) Client
The DHCP client provides a mechanism for allocating IP addresses dynamically
so that addresses can be reused when hosts no longer need them.
This menu determines DHCP on or off.
When DHCP is set to off, you must set static IP address in the following menu.
(When used as Local mode In IPECS system, this setting does not effect)
Setting Static IP Address
You can configure a static IP address, Subnet, Primary Gateway, Primary DNS, Secondary DNS,
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
45
Date: 24/May/2005
Advertisement
Table of Contents
