BL-PA100A/BL-PA100KTA
7.2.
Testing a terminal's network speed
Once you have connected the adaptors where you plan to use them, use the procedure below to test the speed of each termi-
nal's network connection to the master. Make sure that the terminal has already been registered to a master.
1. Press and hold the terminal's SETUP button for about 1 second.
• The indicators on the terminal light one at a time in succession for a few seconds.
2. The indicators light for a few seconds. This indicates the network speed test result.
3. Refer to the chart below to determine the network speed.
4. If you are not satisfied with the speed test result, connect the terminal to a different wall outlet and repeat the test.
Note
• At least one indicator ("Good" network speed) must be lit in order to use the terminal.
• If you are not satisfied with the speed test result and have tried connecting the terminal to different wall outlets, refer to the trou-
bleshooting section.
• If the electrical conditions in your home changes after performing the speed test, network speed may also change.
Once you are satisfied with the termina's speed test result, you are ready to connect each adaptor to a network device (broadband
router, hub, computer, network printer, network camera, etc.).
12