Pbx Configuration—[1-1] Configuration—Slot—V-Ipcs4—Card Property - Panasonic KX-NS1000 Programming Manual

9.18 PBX Configuration—[1-1]
Configuration—Slot—V-IPCS4—Card Property
The properties of the V-IPCS card can be specified.
Signalling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1024–65535
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Signalling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1024–65535
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Signalling (MGCP) UDP Port No. (IP-CS)
Indicates the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-CS side (reference only).
Value Range
2427
Maintenance Console Location
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
Voice (RTP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive RTP (Real-time Transfer Protocol) data on the IP-CS side.
This must be changed if another network application is using the same port.
For voice communications, an IP-CS uses 128 contiguous UDP ports, starting from the port number specified
here.
To change the value displayed here, click Common Settings and set the desired value.
9.18 PBX Configuration—[1-1] Configuration—Slot—V-IPCS4—Card Property
PC Programming Manual 351