Figure 135. M.2 backplane installation
After installing the M.2 drive and M.2 backplane:
1. If you have removed the riser 2 assembly, reinstall it. See "Install a riser card" on page 148.
2. Complete the parts replacement. See "Complete the parts replacement" on page 203.
3. Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
http://sysmgt.lenovofiles.com/help/topic/LXPM/RAID_setup.html
Hot-swap power supply replacement
Use this information to remove and install a hot-swap power supply.
Remove a hot-swap power supply
Use this information to remove a hot-swap power supply.
S035
CAUTION:
.
Chapter 3
Hardware replacement procedures
171