Figure 106. CMOS battery installation
After installing the CMOS battery:
1. Complete the parts replacement. See "Complete the parts replacement" on page 203.
2. Use the Setup utility to set the date, time, and any passwords.
Riser card replacement
Use this information to remove and install a riser card.
Note: Depending on the specific type, your riser card might look different from the illustrations in this topic.
Remove a riser card
Use this information to remove a riser card.
Before removing a riser card:
1. Remove the top cover. See "Remove the top cover" on page 103.
2. If there is any PCIe adapter installed on the riser card, record the cable connections first. Then,
disconnect all cables from the PCIe adapter.
To remove a riser card, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-A25P7vBoGa_wn7D7XTgDS_
• Youku:
http://list.youku.com/albumlist/show/id_50483444
Step 1.
Grasp the riser assembly by its edges and carefully lift it straight up and off the chassis.
.
Chapter 3
Hardware replacement procedures
145