WIT-300H Installation Manual
Issue: 0.1C
(2) Enter SSID.
(3) DTIM configuration is not supported.
Netgear
(1) Open a page "Wireless Settings > Basic" . You can see a edit box "SSID".
(2) Enter SSID.
(3) DTIM configuration is not supported.
2.2.4
Network Parameters
Network parameters such as IP address, netmask, gateway are also to be configured since AP is bridging
between the WIT-300H and the iPECS LIK-300. They are all to be set up with the same values to
those in iPECS LIK-300.
3.
iPECS LIK-300 Setup
3.1
MFIM S/W Version
WIT-300H is recognized as special phone type in MFIM in iPECS LIK-300, version 30.Ah. After
downloading this version image into a MFIM of iPECS, you can see the following figure in WEB
administrator,
This Document Contains proprietary information and may not be reproduced or copied without express
Written permission of a duly authorized representative of LG Electronics company
18
Date:: 30/Jan/05