Advertisement
BIOS setup
1. This procedure sets up the motherboard BIOS.
2. Open the BIOS setup screen. (The method of calling up
the BIOS setting screen varies depending on the
computer. Refer to the user's manual of the computer.)
3. Set "Plug & Play OS" to "OFF". (The setting on your
computer system may be "Disable" or "No".)
4. Set Power Management to "OFF". (This may be "Disable"
or "No".)
5. Save the settings, and quit the BIOS setup screen. The
computer starts up automatically.
6. Once the computer has started up, confirm that it is
operating normally; then quit WindowsNT and turn off the
computer.
Installing the Vide Compression board
(TARGA2000DV board)
Note that due to structural differences, the installation
location may differ depending on the model of computer
used.
1. Remove the cover for the PCI slot (the white connector on
the motherboard) that is closest to the CPU.
Note: The construction of some computers does not
physically allow the TARGA2000DV board to be
plugged into the PCI slot that is closest to the CPU. If
this is the case with your computer, remove the cover
for the adjacent PCI slot.
2. Carefully remove the TARGA200DV board from its anti-
static protective pack. If you need to set the board down,
place it on top of this pack.
3. Attach the board spacer to the main board (the longest
board) among the TARGA2000DV boards. (Refer to the
diagram below.)
Insert the main board into
the grooves in the rail
guides on the board spacer.
5
Main board
Grooves in the rail guide
on the board spacer.
Advertisement
