GE Moisture monitor series 3 Programming Manual page 76

SYSTEM
Mode
CONFIG
The following options depend on
the measurement mode selected.
O – N/A % ppmv
H – N/A TF Mxx Kh
T – N/A TF Mxx Kt
P – N/A TF X1 X2 Kp
Aux 1/2 – N/A I V
Enter low and high reference values
for oxygen, hygrometry, and pressure.
Refer to Entering Reference Values
for a Channel Card in Chapter 2 of
the Service Manual.
Advanced Programming
PROG
AUTOCAL USER
Enter the autocal
interval in hours and
minutes. Limit: 24 hrs.
Sat. Constant Curve
NO
This option appears
only when available.
REF CURVES
The following options depend on
the measurement mode selected.
H –
O – S/N Curve Bkgd
T –
H – S/N #Pts Curve
P –
P – S/N Curve
C. ppmv –
Aux 1/2 – S/N #Pts Curve
Enter passcode Refer to Figure 3-3
LOGGER
STOP STORAGE
A B
Records: X
# Bytes Used: XX
YES
# Bytes Free: XXX
Rem: XX hrs X min
CONSTANT ERROR
The following options depend on
the measurement mode selected.
Constant Temp °C
Kppmv Multiplier
LoRange HiRange
ALM-A ALM-B RCD-A RCD-B
SETUP VIEW
Create Log
Yes No STATUS DATA
Records: X
Log Started at:
# Bytes Used: XX MM/DD/YY HH:MM
Cyclic
# Bytes Free: XXX Time CHX: X.XX
Rem: XX hrs X min HH:MM X.XX
Yes No
Error
Yes No
Start
End
Interval
Enter Log # (1-12)
Measurement Mode
Measurement Units
Finished
Start Logging
Off On
March 2008
3-48