Recording From Radio Broadcasts - Panasonic SC-AK62 Operating Instructions Manual

2
1
2
SC-AK77
4
A
24
RQT5769
only
SC-AK77
2 REC
SC-AK66 SC-AK62

Recording from radio broadcasts

Wind up the leader tape so recording can begin immediately.
Press [c DECK 2 OPEN] and insert the tape.
Close the holder by hand.
SC-AK77
4
Press [REV MODE] to select the reverse mode.
Every time you press the button:
1
,
"
is pressed.
Select a radio station. Perform steps 1 through 3
on page 14.
Press [a REC/STOP] to start recording.
To stop recording
Press [a REC/STOP] again.
Recording can also be stopped by pressing [L].
2
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part while recording
1. Press [a REC/STOP] during the unnecessary part. The cassette
MHz
deck will go into the stop mode.
2. Press [a REC/STOP] to resume recording again. Recording will
continue in the same direction as before.
SC-AK77
To start recording on the reverse side
FLAT
Load a tape and change the tape direction as follows:
1. Press [TAPE, DECK 1/2] and select tape deck 2.
MHz
// J
2. Press [
will be shown as "4".
SC-AK66 SC-AK62
To record on the other side of the tape
Turn the tape over and press [a REC/STOP].
Note
When recording an AM broadcast, sound is momentarily interrupted
when you start and stop the recording.
To reduce noise while AM recording (Beat proof
A
function)
Press [g/(, FM MODE/BP] while recording.
Each time you press the button, "BP1" and "BP2" will be displayed
alternately.
Select the position where there is less noise.
only
: One side, only, records.
: Both sides record (front side ¡ reverse side).
automatically changes to "
"
] and immediately thereafter [L]. The tape direction
a
" when [ REC/STOP]