ENERVISTA SOFTWARE INTERFACE
4.2.3
Installing the EnerVista 745 Setup Software
4–10
FIGURE 4–4: Communications using rear Ethernet port
The following minimum requirements must be met for the EnerVista 745 Setup software to
operate on your computer.)
• Pentium class or higher processor (Pentium II 400 MHz or better recommended)
• Microsoft Windows 98, 98SE, NT 4.0 (SP4 or higher), 2000, XP
• Internet Explorer version 4.0 or higher (required libraries)
• 128 MB of RAM (256 MB recommended)
• Minimum of 200 MB hard disk space
A list of qualified modems for serial communications is shown below:
• US Robotics external 56K Faxmodem 5686
• US Robotics external Sportster 56K X2
• PCTEL 2304WT V.92 MDC internal modem
After ensuring these minimum requirements, use the following procedure to install the
EnerVista 745 Setup software from the enclosed GE EnerVista CD.
Insert the GE EnerVista CD into your CD-ROM drive.
Click the Install Now button and follow the installation instructions to
install the no-charge EnerVista software on the local PC.
When installation is complete, start the EnerVista Launchpad
application.
745 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: INTERFACES
808839A1.CDR