Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
5.2.4
Drive Enclosure Rack Installation Procedure
This section describes how to install a drive enclosure in a rack.
IMPORTANT
Procedure
1
2
■ For the EMEA&I region
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Do
CAUTION
•
If drive enclosures are installed in a way other as described herein,
damage and/or device failure or electrical shock may occur.
•
Do not install drive enclosures with cables, such as power cords,
connected.
•
Do not knock the other devices installed in the rack when installing
drive enclosures.
•
Connect the cables after installing the drive enclosure in a rack by
following the "Add Drive Enclosure" procedure of ETERNUS Web GUI.
•
Install the disk after expanding the drive enclosure.
Wear a wrist strap or touch a metal part to discharge the human body's natural
static electricity.
Attach the rack rails to the rack.
(1)
Attach the 2U rack rail to the left rear rack pillar.
The M5 centering screws should be inserted in the 1st and 6th holes above the base
line of the controller enclosure.
2U Bracket
Copyright 2011 FUJITSU LIMITED
M5 Centering screws (10mm)
65
P3AM-5512-02ENZ0