Trunk Group; Efa Transfer - Panasonic KX-TVA50 Programming Manual

2.5.4 Parameters

Trunk Group

Specifies the parameters for each Trunk Group No.
Follow the steps below to edit a Trunk Group.
1.
Click Click to edit....
2.
Select the desired Trunk Group No. (1–64).
3.
Edit each parameter in the Trunk Group dialog box.
4.
Click OK.

EFA Transfer

Effective for DPT Integration only. Specifies whether or not the VPS uses EFA (External Feature Access) when
transferring incoming trunk (CO line) calls to another trunk (CO line). If set to "Enable", the VPS transfers
incoming trunk (CO line) calls to another trunk (CO line) according to "EFA Transfer Sequence" specified in
"Transfer to Outside". If set to "Disable", the VPS transfers incoming trunk (CO line) calls to another trunk (CO
line) according to "Call Transfer to Outside Sequence" specified in "Transfer to Outside".
Default
Disable
Value Range
Disable, Enable
Caller ID Callback
Specifies whether or not the VPS allows a subscriber to call back the party who left a message in his or her
mailbox by using the caller ID information sent from the PBX. This setting applies to the trunk (CO line) number
used when the message with Caller ID information was left in his or her mailbox.
Default
Disable
Value Range
Disable, Enable
Outside Line Access Sequence for Caller ID Callback
Specifies the sequence of trunk (CO line) access numbers for Caller ID Callback. This parameter is available
when the VPS executes Caller ID Callback without using EFA.
Default
9T
Value Range
Max. 16 digits consisting of 0–9,
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
0–9, , #: Dial Codes
180 Programming Manual
, # and special codes
Document Version 3.0 2010/06