Traction Control System (For Equipped Models) - Yamaha MT09 Owner's Manual

Instrument and control functions
1 Traction control system
(for equipped models)
2
The traction control system (TCS)
helps maintain traction when accelerat-
ing on slippery surfaces, such as un-
3
paved or wet roads. If sensors detect
that the rear wheel is starting to slip (un-
4
controlled spinning), the traction control
system assists by regulating engine
5
power as needed until traction is re-
stored.
6
WARNING
The traction control system is not a
7
substitute for riding appropriately
for the conditions. Traction control
cannot prevent loss of traction due
8
to excessive speed when entering
turns, when accelerating hard at a
9
sharp lean angle, or while braking,
and cannot prevent front wheel slip-
10
ping. As with any motorcycle, ap-
proach surfaces
slippery with caution and avoid es-
11
pecially slippery surfaces.
12
The " " indicator light flashes when
traction control has engaged. You may
EAU73141 notice slight changes in engine and ex-
haust sounds when the system has en-
gaged.
In certain conditions, the traction con-
trol system may be automatically dis-
abled. Should this happen, the "
indicator light and the "
light will come on.
The TCS display (page 3-10) indicates
the current TCS setting. There are
three settings.
TCS "OFF"
EWA15432
TCS "OFF" turns the traction control
system off.
TCS "1"
TCS "1" minimizes traction control sys-
tem assist.
TCS "2"
TCS "2" maximizes traction control as-
sist; wheel spin is most strongly con-
that may be
trolled.
TIP

Use the traction control switch
(page 3-17) to change TCS set-
tings.


"
" warning

NOTICE
Use only the specified tires. (See
page 6-16.) Using different sized
tires will prevent the traction control
system from controlling tire rotation
accurately.
Resetting the traction control sys-
tem
The traction control system will auto-
matically disable when:



3-21
Traction control can be turned on
or off only when the vehicle is
stopped.
When the key is turned to "ON",
traction control is turned on and
set to TCS "1" or "2" (whichever
was last selected).
Turn the traction control system off
to help free the rear wheel if the ve-
hicle gets stuck in mud, sand, or
other soft surfaces.
the front wheel or rear wheel
comes off the ground while riding.
excessive rear wheel spin is de-
tected while riding.
either wheel is rotated with the key
ECA16801