Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Doss PF18 YCD15A
- Page 1 PF18 DOSS 18L PORTABLE FRIDGE DC12V/24V COMPRESSOR REFRIGERATOR...
- Page 2 Caution: Read the instructions and safety warnings carefully before using the refrigerator. DESCRIP TION The YCD15/18A represent professional refrigerators that can only be attached to the inside of motor vehicles. They are powered by a 12-24 VDC direct-power supply, which can be accessed directly from the cigarette lighter, found in the passenger compartment of the vehicle itself.
-
Page 3: Data Sheet
DATA S HEET MODEL YCD15A YCD18A E xternal dimensions (HxLx D ) 360x235x565 (mm) 405x235x565 (mm) N et weight 8,5 Kg 9,5 Kg Installed power 35 W 35 W Supply voltage DC 12-24 V DC 12-24 V E lectrical power (within the Fuse 10A Fuse 10A shell) -
Page 4: Installation
ENGLISH INSTALLATION - Place the refrigerator on a dry, protected surface, away from corners. Do not use the refrigerator in uncovered, outdoor areas or areas exposed to the elements. - The refrigerator requires good ventilation. Leave a space of at least 15 cm across all its sides. - Avoid placing the refrigerator near to a heat source, for example, a cooker, radiator or exposing it to direct sunlight. -
Page 5: Control Panel Description
ENGLISH CONTROL PANEL DESCRIPTION Start key SET Battery protection key Display Temperature decrease or scroll menu key Temperature increase or scroll menu key To increase the temperature of the cooling compartment press key 5 until the desired value appears on the display. - Page 6 The refrigerator includes a settings menu, from where it is possible to modify values and thresholds set by 1 (OFS) OFF-SET value 2 (F-C) Fahrenheit or Centigrade settings To access the menu, press, with the refrigerator powered but off, keys 2-4-5 at the same time for a few moments.
-
Page 7: Off -Set Value
OFF -SET VALUE The OFF-SET value refers to the difference between the temperature inside the cooling compartment and the temperature set and presented on the display. It is possible to set three different OFF-SET levels dependent on the temperature set on the display. The recommended OFF-SET value is 2°C, in order to achieve a temperature within the cooling compartment which corresponds with the temperatures presented on the display. -
Page 8: Maintenance
FAULTS Any operation faults will be displayed after 90 seconds and will be presented on the display with the following codes: The ventilator is sending the control unit a value which exceeds 0.6A: The compressor is blocked: The cooling system holds too much gas and the compressor is not able to operate at the minimum number of revolutions/rpm: The ambient temperature is too high: The thermostat has short-circuited or is not correctly connected to the control unit:...