Pfaff Creative 1471 Instruction Book page 63

02/14/2008
Cause:
Remedy:
5. Machine feeds irregularly or not at all
Lint has accumulated between tooth Remove needle plate and clean out lint.
rows of feed dog.
Feed dog dropped. (Drop-feed control is
Flick drop-feed control to the left.
at right).
6. Machine runs with difficulty
Thread ends in hook raceway. Remove thread ends and put a drop of
oil into hook raceway.
7. Electronic bobbin thread monitor does not work
Thread ends and dirt have collected in
Remove thread ends and dirt. Special
the free arm cover over the indicator
care should be taken in the area round
lamp, in the hook raceway, in the bobbin the second indicator lamp.
case, behind the hook and on the
second indicator lamp to the right behind
the hook.
8. Machine does not sew the program entered
Switch the machine oft, wait about 30 seconds, then switch it on again. Again enter
the desired program.
9. The sewing lamp lights up, but the machine does not run
Fuse ist faulty. Insert new fuse.
lmportant
Never run a threaded machine unless there is a piece of fabric under the sewing
foot. If you have to leave the machine, even for a short while, be sure to switch off
the master switch. This is particularly important when children are around.