Ring Powering PowerSource RINV150 User Manual

Specifications
PowerSource Model RINV150
Max. Continuous power (Watts)
Peak Power (Watts) 0.01 Seconds
No load current draw (AMPS)
Waveform Modified Sine
Input Voltage Range 10 – 15 Volts DC
AC Socket 3 Pin Mains
Fuse
Weight (kgs)
Dimensions (mm) 140 x 137 x 52
Troubleshooting Guide
Symptom Possible causes
AC appliance will not operate; 1. Battery has discharged to 10v.
the audible alarm is sounding.
2. The inverter has overheated. This
could be due to poor ventilation.
3. Poor battery condition
AC appliance will not operate; 1. Inverter is overloaded.
the audible alarm is not
sounding. 2. Internal fuses have blown.
3. fuse in cigarette lighter plug
has blown.
Above sympton when using the 4. Vehicle fuse has blown as the
cigarette lighter plug on the maximum wattage using the
RINV300 cigarette lighter plug is 180 watts.
Run time is less than expected 1. Internal battery is not fully
charged.
2. AC appliance power
consumption is higher than
expected.
For further assistance: Technical Helpline: +44 (0)113 276 7244
Distributed by:
Ring Automotive Gelderd Road, Leeds LS12 6NB
Tel: +44 (0)113 276 7676 Fax: +44 (0)113 231 0266
Email: autosales@ring.ltd.uk
RINV300
150
300
<0.15 <0.25
Modified Sine
10 – 15 Volts DC
3 Pin Mains
20 amp 40 amp
0.8
203 x 137 x 52
Possible solution
Turn off the inverter on/off switch
and recharge the battery.
Turn off the inverter and allow to
cool for 10 mins.
Replace battery.
Reduce load, not exceeding
maximum rating.
Fuse replacement (qualified
electrician only).
Replace fuse in cigarette lighter
plug - 15 amp.
Replace vehicle fuse and ensure if
using cigarette lighter plug the
wattage does not exceed 180
watts. Above this connect directly
to the vehicle battery.
Recharge the battery.
Check AC appliance wattage
rating is within scope of inverter.
4
330
PowerSource
600
Mains powered equipment from a 12v source
1.1
User Manual
12v DC to 230v AC Power Source
150 & 300 Watts