zoet dS1 AMP1-250 Setup Manual

zoet dS Series Setup Guide
The zoet dS AMP Series consists of both IP based amplifiers and IP based digital to analog converters
(DACs). This Quick Setup Guide is intended to help facilitate a quick and easy way to setup your dS AMP
Series product for zöet with Ethernet connectivity, or playGo with Wireless connectivity. For the
purpose of this Guide, instructions are provided for the dS2 AMP versions. However as long as the dS2
DAC is connected to a powered amplifier or powered speakers the same instructions can be followed.
What's in the box:

dS1 AMP or dS2 AMP IP based amplifier

IEC power cord

Ethernet Cable

This document
Specifications:
Mono or Stereo
Output power into 4Ω
Output power into 8Ω
Frequency response
THD
Power requirements
Typical power usage
Rack mountable
Dimensions
Shipping weight
What you need before you get started:

To use the dS AMP with zoet you will need a zoet dB1 with an Ethernet-based network.
OR

To use the dS AMP Series products wirelessly with playGo you will need a playGo USB tx
(transmitter).

Passive speakers (Powered Speakers or Power Amplifier for dS2 DAC)

Speaker cables (RCA Cables for dS2 DAC)

AC inlet for power
About the dS AMP Series
This guide is believed to be correct at the time of publication and BICOM takes no responsibility for
consequences from printing error or inaccuracies. Specifications are subject to change without notice.
dS1 AMP1-250
Mono
1x210W
1x120W
20Hz – 20kHz +0.3/-0.5dB
~0.0055%
120 VAC 3.15A 60Hz/ 250
VAC 2.5A 50Hz
<10W
Yes
3" X 8" X 8.5"
Approximately 7 lbs
dS2 AMP1-90
Stereo
2x90W
2x50W
20Hz – 25kHz +/- 0.5dB
<0.05% up to 75Wrms
120 VAC 5.15A 60Hz/
250 VAC 4.15A 50Hz
<8W
Yes
3" X 8" X 8.5"
Approximately 5 lbs
dS2 AMP1-125
Stereo
2x125W
2x65W
20Hz – 20kHz +/-0.15dB
~0.003%
120 VAC 5.15A 60Hz/
250 VAC 4.15A 50Hz
<10W
Yes
3" X 8" X 8.5"
Approximately 5 lbs