Page 2
WARNING: FAILURE TO FOLLOW THIS GUIDE MAY RESULT IN SERIOUS INJURY! USING THIS MACHINE WITH RESPECT AND CAUTION WILL CONSIDERABLY REDUCE THE RISK OF PERSONAL INJURY. SAFETY GUIDE FOR THE EZ SHEAR SST SERIES ™ 1 �����READ AND UNDERSTAND THIS INSTRUCTION MANUAL BEFORE OPERATING THE EZ SHEAR �...
Page 3
You will need #2 & #3 Phillips head screwdrivers SST220 SET Up and a 1/2” (13mm) socket or wrench. Please Review and Verify Parts Included in Box: 1. Power Assembly 1a. Safety Lock pin 2. Handle Assembly 3. Fence 4. Table 5.
Page 4
ASSEmbly 1. ATTAcH RAIlS 2. ATTAcH TAIl Attach rails and mounting bracket to Power Assembly Attach tail and mounting bracket to rails using base using Item A machine screws, fitted with Item B Item C machine screws. Make sure holes in tail are star washers.
Page 5
PlAcE THE FEncE For 220: Your EZ Shear is equipped with an aluminum fence which may be set to common roof pitches. (4/12, 6/12, 8/12, and 12/12) Simply align with desired position and press pins into place. Note: The fence is friction fit (requires effort to insert or remove).
Page 6
The 226 Shear has two Leverage Modes Mode 1: Use the long-stroke cams (black lobes) only for lightweight products thicker than 1/2 inch. Mode 2: For all other recommended products, use the short-stroke cams (grey lobes). Leverage Switch Instructions Engaging the Short-Stroke Cams ...
If extreme pressure is required to cut AccESSORIES a product, it may result in damage to your machine. Please contact Bullet Tools before proceeding. Warranty is void if an unapproved product damages the machine. All Angle Fence Item #701AF...
This warranty does not cover any damage due to accident, misuse, abuse or negligence. Further, it is valid only if the product is used with the cut products specified in the cut guide. Please refer to the User Guide for details or call Bullet Tools™...