Illumra SR04 Installation Manual

SR04 - Room temperature sensor only
SR04P - Room temperature sensor with set point adjustment
SR04PT - Room temperature sensor with set point adjustment,
presence key (pictured)
SR04PST - Room temperature sensor with set point adjustment,
presence key, fan speed switch)
SR04P MS - Room temperature sensor with set point
adjustment, slide switch O/I
SR04 rH (Room sensor humidity/temperature)
SR04P rH - Room sensor humidity/temperature with set point
adjustmen)
SR04PT rH (Room sensor humidity/temperature with set point
adjustment, presence key)
SR04P MS rH (Room sensor humidity/temperature with set point
adjustment, slide switch O/I)
Overview
The ILLUMRA Wireless Temperature sensor detects the temperature of a room and transmits to compatible HVAC and/or humidity
TM
controllers, and/or ventilation devices. Users can also adjust temperature settings manually through its optional set point dial. For use in
consistantly dark areas, it can be used with an optional lithium battery. Depending on the specific model, the SR04 comes equipped with
an integrated temperature sensor, humidity sensor, rotary knob for set pont adjustment, rotary nob for fan speed adjustment, and/or a
presence button or slide switch.
Compatible Devices
■ RF Serial Box; E3X-232FP
■ Ethernet Gateway; E3X-E18-XS1
■ More
Components Included
The following items are included with this product:
■ A -- () ILLUMRA Temperature Sensor
■ B -- () Square of mounting tape
Tools Needed for Installation
■ Screwdriver
■ Screws (if a screw mount is desired)
■ Needle-nose pliers (if you wish to change the Transmission Time)
Installation
To install the Temperature Sensor select a method from the options below. Follow the instructions for that method. For receiver
installation instructions, see appropriate installation guide(s).
CAUTION/NOTES:
Copyright © 2009 ILLUMRA. All rights reserved.
Installation Guide
Wireless Room
Temperature Sensor
Optional: occupied button, slide
switch, set point, fan selector,
humidity sensor
Contact ILLUMRA: T: (80) 349-200 | F: (80) 653-4257
■ Always follow local electrical codes when installing this device. Installation should be performed by a qualified technician.
■ ILLUMRA products are intended only for use indoors, in dry locations, and with permanantly installed fixtures.
■ ILLUMRA products should NOT be installed in a location where the unit will be in close proximity to the light bulb(s)
or other sources of heat, such as above a ceiling hugger fixture, particularly with higher wattage loads. Installation in
close proximity to light bulbs or other heat sources may subject the receiver to temperatures exceeding the operating
temperature rating (see "Operating Temperature" on specifications table).
■ Installation in metallic enclosures or near large metal objects will typically reduce radio range.
SELECT  OF THE FOLLOWING APPLICATIONS:
Adhesive mount
Note: If you are unsure if a desired location is suitable for the Temperature Sensor, test its functionality in that location
before installation. For guidelines on choosing a location refer to the sections in these instructions entitled "Selecting
the Mounting Place for Solar Energy Storage" and "Transmission Range."
Step : Peel the lining paper off of one side of the square of mounting tape (B) included.
Step 2: Affix the exposed mounting surface squarely to the back of the Sensor.
Step 3: Peel the lining paper off the other side of the square mounting tape.
Step 4: Affix the exposed mounting surface squarely to the desired location.
Screw mount
Step 1: Remove the backplate as shown below.
Open cover here
Step 2: Mount the backplate to the wall using appropriate screws (not included).
Step 3: Snap the Sensor onto the backplate.
| Info@ILLUMRA.com | www.ILLUMRA.com
(Dimensions in mm)
AHD0255A