Sawgrass C88 Installation Instructions

C88/C87/D88 Quick Connect Installation Instructions
1. Clamp the tubes at the end of each line to prevent ink from entering
the line before you clip on each bag. Then insert the ink bags into the
ink box by clipping them into the connectors inside the box. Each se
tion is marked with which color ink should be placed there.
1. Turn the printer on, lift the lid,
and press the ink button
4. Insert the plastic cross bar into place by sliding the notched end into the back

Before you Begin

It is crucial that the OEM ink supplied with your printer is installed before you attempt to install your
SubliJet IQ™ inks. This allows for two things: First, it primes the ink delivery system, ensuring that
the SubliJet IQ™ ink will load more easily. Second, it familiarizes you with the basic operation of
your printer. Please see the EPSON Stylus C88/C87/D88 Printer User's Guide for instructions on
installation.
C88/C87/D88 Printer Setup Instructions
2. The cartridge bay will shift into
the remove position. Remove any
installed cartridges.
of the chip holders as shown.
For more detailed instructions please refer to the C88/C87/D88 Getting Started
Guide or the Video Installation Guide on your PowerDriver
Please read this document thoroughly before installing the
system to prevent voiding your warranty.
Components
1. Ink Cartridge + tubes
2. 1 x Long Tube Grip
3. 1 x Short Tube Grip
4. 4 x Ink Bags
5. Small primer bottle
6. Ink Box
7. Chips
8. Foam Block
9. Power Driver CD (Not Shown)
10. Printer
2. Use the priming bottle to prime each line. To do this, unhook the clamp at
the end of the line and squeeze the priming bottle to release all the air then
insert it into the bottom of the cartridge to prime the line and fill it with ink.
c-
Once ink is in the reservoir, pinch together the clamp at the end of the line.
3. Install the cartridge chips in the cartridge slot on the front of the car-
tridge bay. Note: The chip has an up arrow on the back of it showing
which way it should go in the printer.
5. Gently slide the cartridges through the hole in the
cartridge cover. Start with the black cartridge on the
Do this for each cartridge.
left and attach the cartridges in this order:
(from left to right)
Black, Cyan, Magenta, and Yellow
CD
™
Page 1