Bap IWR-220XR Operation Manual

Battery Charger (HC-10)
Handheld Mic Charger Holder (HC-20)
OPERATION:
1. Connect the Adaptor to wall outlet.
2. Insert the infrared wireless mic to the
charger.
3. The red LED of charger will light up
during charging. Charging time will be
approx. 3.5 hours.
4. When charging is completed, the
green LED indicator will turn on and
red LED turn off.
Note: Be sure to use specified battery
only. You can not charge other
type of battery. Do not use any
battery and battery charger other
than specified.

Connection Diagram

OPERATION:
1. Connect the DC plug of the adapter to the DC
socket of the charger.
2. The indication lamp is red when charging.
3. Press charge/discharge button once for
discharge (yellow) and press one more time
that will be back to charging status (red).
4. When full charge, (green) and sounded.
5. When connect the charging plug to the ring
output socket of the charger, the right
charger's trough could be an external charge.
6. The full charge capacity is 700mAH.
Flat 04, 2/F., Yuen Fat Industrial Building,
25 Wang Chiu Road, Kowloon Bay,
Kowloon, Hong Kong
Tel: (852)2571 8289 Fax: (852) 2571 0289
Web site: www.bap.com.hk
Email: info@bap.com.hk
IWR-220XR
Cautions:
l Do not cover the infrared emitter area of the wireless microphone or the
surface of the infrared sensor, which may disturb the unit and cause
abnormal operation.
l Since the unit uses infrared reflectance. Do not expose receive to the black
ceiling or wall which may cause abnormal operation.
l Do not near the speaker which may cause howling.
l
Do not drop and wet microphone.
l Do not replace the battery when power is on.
l Do not install the unit a location near heat source or in a place subject to
direct sunlight, excessive dust, mechanical vibration or shock.
Functions of Receiver IWR-220XR
Front Panel
1. Power indicator
2. Channel indicator
l
Green LED will light up accordingly when receives the infrared signal
from microphone.
3. Mic outputs (A+B Mix)
l
Microphone output jacks that connect the mixed microphone output with
cable provided to the amplifier.
4. Mic/Line output level switch
l
It changes the output level of the microphone. Set it to LINE when
connecting the output jack to the AUX input of the amplifier or set it to MIC
when connecting the MIC jack of the amplifier.
5. Infrared sensor inputs
l
Connect to infrared external sensor.
6. Power switch
l
Press it down to turn on the receiver, the power indicator will light up.
Press it again to turn off, the power indicator will go off accordingly.
7. AC cord
l
Supplies power to the unit.
Operation Manual
Rear Panel