DeView D410-THRE3V12L Instruction Manual

INSTRUCTION MANUAL

COLOUR VANDAL PROOF CAMERA
D410-THRE3V12L / D410-THRN3V12L
D410-THRE3V12LHTR / D410-THRN3V12LHTR
About this Manual
Before installing and using the camera, please read this manual carefully.
Be sure to keep it handy for later reference.
Dimensions : mm

TROUBLESHOOTING

Before sending the camera out for repair, check the items
below. If the problem persists after checking these items,
contact your service center.
■ If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE. ENSURE ALL CABLE
ENTRY POINTS ARE SEALED TO PREVENT ENTRY POINTS ARE SEALED TO PREVENT
MOISTURE INGRESS
PRECAUTIONS
■ Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.
■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get insdie the camera. It could cause fire, short-circuits or
damages.
■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject
it to strong shock or vibration.
■ Install away from electric or magnetic fields
■ Protect from humidity and dust
■ Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen
or boiler room, as the temperature may raise to high levels.
■ Cleaning
Dirt can be removed from the cabinet only by wiping it
with a soft cloth moistened with a soft detergent solution.
■ Mounting Surface
The mounting surface material must be strong enough to
secure the camera.
■ Ingress Protection
Ensure all cable entry points are sealed with silicone sealent
i i
to prevent moisture ingress.
CONNECTOR AND CAMERA SETTING
■ CONNECTIONS
DC12V / AC24V
DC12V / AC24V
CAUTION :
Check for polarity when using a DC 12V or AC 24V power supply.