Enzyme/manual defrost freezer plus series (15 pages)
Summary of Contents for Lab Research Products MCFB-2020
Page 1
C Manual Defrost Freezer (Upright) MFB-2030 –30 C Manual Defrost Freezer (Upright) MCFB-2020 –20 C Manual Defrost Freezer (Chest) How to operate and care for your appliance and how to get the best, as well as the READ THIS BOOK! Note to Customer: This merchandise was carefully packed and thoroughly inspected before leaving our plant.
This is only normal functioning of the motor overload protector. The motor compressor will cycle normally as soon as the excess heat has been removed. Temp -20° -20° (MFB/MCFB-2020) -30° (MFB/MCFB-2030) -20° VOLTAGE SHOULD NOT VARY MORE THAN 5% FROM SERIAL...
OPERATING INSTRUCTIONS AUTOMATIC TEMPERATURE CONTROL – The control is pre-set to maintain the ideal temperature of this appliance. If necessary, temperature can be adjusted using minimal increments. MFB-0920: The temperature control is located in the “hood” directly above the door MFB-2020: The temperature control is located on right side wall inside cabinet MFB-2920: The temperature control is located behind the louvered grill at the bottom of unit MFB-2030: The digital temperature control is factory preset and is not adjustable...
Lab Research Products PRODUCT WARRANTY Lab Research Products warrants to the original purchaser every new Lab Research Products refrigerated unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, under normal use and service, for a period of two (2) years. The warranty period starts two weeks from the date of shipment from Lab Research Products.
Page 6
TRANSPORTATION COSTS. Lab Research Products will accept parts covered under this warranty freight collect, provided that shipment has received prior approval. OUTSIDE U.S./CANADA. This warranty does not apply to, and Lab Research Products is not responsible for, any warranty claims made on products sold or used outside the United States and Canada.
This section pertains to -30°C FREEZER ONLY This freezer has been factory set to run at -30°C. The external thermostat may require adjustment depending on the final ambient operating condition. The freezer has reserve range and can operate to -35°C, depending on load and ambient temperature.
Programming Steps and Display The ETC can be programmed in four simple steps using the LCD display and the three keys on the face of the control. Step 1 - To start programming, press the SET key once to access the Fahrenheit/Celsius mode.