DIGI-HD-UHR2-WP Installation
Manual
The Intelix DIGI-HD-UHR2-WP transmits HDMI up to 300' over
a single twisted pair cable. In environments with high
electromagnetic interference (EMI), shielded twisted pair
cable should be used.
Built-in HDshāk® technology provides dynamic HDMI,
EDID/DDC
and
HDCP
mode
performance and image quality. Plus, onboard HDMI
amplification and buffering allows multiple extenders to be
daisy-chained for greater distances.
The DIGI-HD-UHR2-WP features electrostatic discharge (ESD)
protection circuitry which safegaurds the HDMI circuit against
static electricity and other destructive stray voltage.
Compatible Devices
Compatible Receivers: DIGI-HD-UHR2-R, DIGI-HD-UHR2-WP-R
Compatible Transmitters: DIGI-HD-UHR2-S, DIGI-HD-UHR2-
WP-S, DIGI-HD-4X2, DIGI-HD-4X4, DIGI-HD-4X8, DIGI-HD-8X8
Maximum Recommended Distances
1080p
1080i
Cat 6a
150'
300'
(shielded)
Cat 6
110'
220'
Cat 5e
100'
200'
selection,
guaranteeing
720p
576i/p
480i/p
300'
300'
300'
220'
220'
220'
200'
200'
200'
8001 Terrace Ave.
Suite #201
Middleton, WI 53562
Important notice:
Do not attempt to disassemble or alter the extender
housing. There are no user-serviceable parts inside the
unit. Doing so will void your warranty.
To minimize the possibility of equipment damage from
electrostatic discharge (ESD), all source and destination
equipment must be powered off during installation.
Do not connect the extender to a telecommunication outlet
wired to unrelated equipment. Doing so may damage the
unit or any connected equipment. Ensure all connected
twisted pair cabling is straight-through (point-to-point).
Allow proper ventilation to reduce the risk of thermal
failure.
The Intelix DIGI-HD-UHR2-WP conforms to HDMI and HDCP
specifications. Intelix does not guarantee operation with devices that
do not conform
to these
specifications.
The Intelix DIGI-
HD-UHR2-WP
complies with
HDCP
standards.
Distances
and
picture quality
may be affected
by cable grade,
cable quality, source and destination equipment, RF and electrical
interference, and cable patches.
Instructions
1. Turn
off
power
audio/video equipment by following the
manufacturer's instructions.
2. Adjust DIP switches for desired mode.
3. Connect all twisted pair cables (ensure T568B
straight-thru wiring).
4. Connect all HDMI cables.
5. Connect power supplies.
6. Power on attached audio/video devices.
and
disconnect
the
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833