Setting The Time, Date And Alarm - Jazwares Lalaloopsy Alarm Clock User Manual

OPERATION USING THE CURRENT ADAPTER:
First of all, make sure the main switch is in the TRY ME position, plug the adapter and
then turn the unit to the ON position. This appliance can be used with a 200mA,
4.5V A/C adaptor. The connector is located at the rear of the Alarm Clock (see FIG.1).
The use of a current adapter which is not officially approved may damage the device
and invalidate the warranty. The transformers or battery chargers used with the product
should be regularly checked for signs of any damage to the wire, plug, casing or any
other parts. If there is any damage, the item should not be used with that transformer
or battery charger until it has been repaired. The item should only be used with the
recommended transformer.

Setting the Time, Date and Alarm:

When you press any of the buttons on the Alarm Clock, the lights on the screen
will come on. If you do not press any of the buttons, they will go out again after
a few seconds.
SETTING THE TIME ON THE CLOCK:
Press the ALARM/TIME SET button (see FIG.4) for a few seconds to access the
time set function. When the display shows the time (alarm) flashing (see FIG.5):
Press SELECT to access the time and date settings. Press SET to change the hour.
Press SELECT to change to minutes, press SET until you reach the minutes desired.
SETTING THE DATE ON THE CLOCK:
Follow the same procedure to continue with the date;
Press SELECT again until the year of the date flashes, choose the year with the
SET button.
Press SELECT to access the month, SET to reach the month, SET to reach the month
and SELECT again to access the day.
Choose the day using SET again, pressing SELECT again to access the day of
the week, and SET to select it.
Finally, press ALARM/TIME SET to confirm the data.
SETTING THE ALARM:
Press the ALARM/TIME SET button for a few seconds. The alarm time will flash first,
enabling you to change the time of the alarm.
Repeatedly press SET until you reach the hour required, press SELECT to choose
the minutes option and select this by pressing SET until minutes desired are shown.
Press ALARM/TIME SET to confirm.
You can move forward more quickly by holding in the SET button.
-5-