JVC HR-S7700EU Instructions Manual page 50

50
EN
AUTO SP LP TIMER
8 ]
ON
OFF
DIGITAL 3R
8
ON
OFF
POWER SAVE
8
ON
OFF
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
When this function is set to "ON", the recorder
automatically switches to LP mode to allow complete
recording if there is not enough tape to record the entire
programme while timer-recording in SP mode.
For Example . . .
Recording a programme of 210 minutes in length onto a
180-minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set this function to "ON", before the timer-
recording starts.
NOTES:
If you have programmed the recorder to timer-record 2 or more
programmes, the second programme and those thereafter may
not fit on the tape if you set "AUTO SP
this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
In order to ensure that the recording fits on the tape, this feature
may leave a slight non-recorded section at the end of the tape.
There may be some noise and sound disturbance at the point on
the tape where the recorder switches from SP to LP mode.
The Auto SP LP Timer feature is not available during ITR
]
(Instant Timer Recording), and the feature will not work properly
with any tapes longer than E-180, or with some tapes of shorter
lengths.
If you perform timer recording with both VPS/PDC and the Auto
SP LP Timer activated, and the programme goes beyond its
]
originally scheduled length, there may be times when the
programme cannot be recorded in its entirety.
When this function is set to "ON", the Digital 3R picture
system applies edge correction to the luminance signal to
enhance detail.
NOTES:
Normally it is recommended to keep "DIGITAL 3R" set to
"ON".
Depending on the type of tape being used, picture quality may
be better with "DIGITAL 3R" set to "OFF".
If you use the recorder as the source player for editing, be sure
to set "DIGITAL 3R" to "OFF" before starting.
When this function is set to "ON", you can reduce the
power consumption while the recorder is turned off.
NOTES:
During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (
... the picture may be distorted momentarily when you turn on/
off the recorder.
Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder's power is turned off after timer-recording or
Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is
engaged ( pg. 34).
... "L-2 SELECT" is set to "DECODER" or "SAT" (
Approximately 60 minutes
LP mode
LP TIMER" to "ON". In
]
pg. 60) does not work.
pg. 37).