JVC HR-S7700EU Instructions Manual page 29

D
Set the tape speed.
p
Press SP/LP ( ).
E
Set the VPS/PDC mode.
Press VPS/PDC to select "ON" or "OFF".
If "VPS/PDC ON" is displayed on the TV screen or "VPS/PDC"
is lit on the front display panel, VPS/PDC is set to ON.
If "VPS/PDC OFF" is displayed on the TV screen or "VPS/PDC"
is not lit on the front display panel, VPS/PDC is set to OFF.
"VPS/PDC Recording" on page 31.
F
Return to the normal screen.
Press PROG or OK. "PROGRAM COMPLETED" appears
on the TV screen for about 5 seconds, then the normal
screen appears. If "PROGRAM OVERLAPPED" appears
on the TV screen and "Err" on the front display panel, see
page 33.
Repeat steps 1 – 6 for each additional programme.
G
Engage the recorder's timer mode.
#
Press (TIMER). The recorder turns off automatically
#
and " " appears on the front display panel.
To disengage the timer mode, press
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday — Friday). Either "WEEKLY" or "DAILY"
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on the TV screen and
"FULL" appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes ( pg. 32).
It is not possible to timer-record a TV programme with a
S V number which starts with "0".
HOW IEW
#
(TIMER) again.
Satellite Receiver Users
To timer-record a satellite broadcast using the S
system:
A Perform "Satellite Receiver Control Setting" on page 15.
B Perform steps 1 – 7. In step 3, the front display panel
shows "L2" for the channel position. In step 5, you cannot
set "VPS/PDC" to "ON".
C Leave the satellite receiver's power on.
ATTENTION
Guide Program Number Set
"GUIDE PROG SET" appears after performing step 3 if the
Guide Program number for the S
entered has not been set.
If you want to set the Guide Program number for the satellite
broadcast station, press the NUMBER key "0" to change "TV
rt
PROG" to "SAT". Press
number on which your recorder or satellite receiver receives
that station, then press OK or
number. The S V Program screen appears.
HOW IEW
EN
V
HOW IEW
V number you
HOW IEW
to input the channel position
e
to set the Guide Program
(Example)
To timer-record a ZDF
programme with the
S V system.
HOW IEW
* If your recorder receives ZDF on
the channel position 2, press OK
e
or after entering "2".
29