Engine Installation, Typical - Polaris INDY TRAIL RMK Service Manual

Engine Installation, Typical

1. Prepare chassis for engine installation by moving
hoses and wiring out of the way.
2. If model is equipped with a torque stop, loosen
locking screw and turn torque stop in to gain
clearance when installing engine.
NOTE:Torque stop must be adjusted properly after clutch
alignment (see chapter 5, clutches)
3. Check condition of bonded rubber engine mounts.
Be sure mounts are tight before installing engine.
With engine mounting plate or mount straps installed
on engine, set engine on rubber mounts and loosely
install mounting bolts and nuts.
4. Install drive belt (and clutch if removed) and check
clutch offset/alignment. Adjust torque stop (where
applicable). Refer to chapter 5, clutches, for torque
stop adjustment procedure.
5. Tighten engine mounting bolts to specification.
Engine Mounting Bolt Torque-
Front - 28 Ft lbs (67 Nm)
Rear - 28 Ft lbs (67 Nm)
ENGINES
3.9