Cleaning And Preservation Of Hood, Chassis And Trim; Controls And Linkage; Electrical Connections; Clutch And Drive System - Polaris INDY TRAIL RMK Service Manual

MAINTENANCE / TUNE UP

Cleaning And Preservation Of Hood, Chassis And Trim

Proper storage starts by cleaning, washing and waxing the hood, chassis, upholstery and plastic parts. Clean and
touch up with paint any rusted or bare metal surfaces. Ensure that all corrosive salt and acids are removed from
surfaces before beginning preservation with waxes and rust inhibitors (grease, oil, or paint).
If the machine is equipped with a battery, disconnect the battery cables and clean the cables and battery posts. Fill
battery to proper level with distilled water and charge to full capacity. Remove and store the battery in a cool dry
place.
The machine should be stored in a dry garage or shed out of the sunlight and covered with a fabric snowmobile
cover. Do not use plastic to cover the machine; moisture will be trapped inside causing rust and corrosion
problems.

Controls And Linkage

All bushings, spindle shafts and tie rod ends should be coated with a light coat of oil or grease. Throttle controls
and cables should be lubricated. Force a small amount of lubricant down cables.

Electrical Connections

Separate electrical connector blocks and clean corrosive build-up from connectors. Lubricate or pack connector
blocks with Nyogelt grease and reconnect. Replace worn or frayed electrical wire and connectors.
Nyogelt Grease PN 2871329

Clutch And Drive System

Remove drive belt and store in a cool dry location. Lubricate sheave faces and ramps of drive and driven clutches
with light oil or rust inhibitor. All lubrication applied as a rust preventative measure must be cleaned off before
installing belt for service and operating machine.
Chaincase Lubricant
Change chaincase lubricant as outlined in this section. Remove the outer cover and clean the chaincase
thoroughly.
2.20