Hasselblad 3053310 User Manual

USER MANUAL
Battery Adapter & Battery Adapter Plates
Battery Adapter
The Battery Adapter (3053310) allows a standard 7.2
V "Sony™ NP-F / L-type" battery (not supplied) to be
directly mounted onto an H5D, H5D-MS or H4D-60
sensor unit to provide stand-alone operation when
FireWire operation is not possible. This is especially
useful when using the H5D sensor unit attached to a
technical camera on location, for example.
There are three different Battery adapter plates
(supplied as separate items) that support the
mounting of the adapter to the three sensor units
respectively; 3053312 for H5D, 3053314 for H5D-50
MS and 3053316 for H4D-60. Please ensure you
have the correct version.
Fitting
1. Invert the sensor unit as in the illustra-
tion.
Remove the protective rubber cover that
shields the connector port. Keep it safe
for later use.
2. Remove the two screws (H5D) / four
screws (H4D) from the lower plate on the
sensor unit.
Choose the correct FixPlate that suits the
sensor unit model:
3053312 for H5D
3053314 for H5D-50 MS
3053316 for H4D-60
The information in this document is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Victor Hasselblad AB. The text and images in this document cannot be reprinted or reused without the express permission of Victor Hasselblad AB. Victor Hasselblad AB assumes no
responsibility or liability for any errors or inaccuracies that may appear in this document. Victor Hasselblad AB assumes no responsibility or liability for loss or damage incurred during or as a result of using Hasselblad products. Copyright © 2013 - Victor Hasselblad AB. All rights reserved.
www.hasselblad.com
Item nos. 3053310, 3053312, 3053314, 3053316
In each case, the Battery adapter plate is attached
to the sensor unit first followed by the Battery
Adapter. A small cross-headed screwdriver (size:
PH1) is needed for both operations.
The Battery adapter plate can remain attached
to the sensor unit when the Battery Adapter is not
required. It only takes a few moments to remove or
attach the Battery Adapter to the Battery adapter
plate when required.
H5D has
two screws
H4D has
four screws
1/3 Document ID: Battery Adapter and Plates _3053310_12_14_16_User Manual D_V1_2013