Download Print this page

HouseWarmer HWFMC-72UH-1 Installation Instructions

Mantel surrounds and mantel shelf

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS

INSTRUCTIONS MUST BE LEFT WITH OWNER FOR FUTURE REFERENCE AFTER INSTALLATION.
Recommended for use with most fireplaces from 32 to
42 inches wide and up to 38 inches tall. Reference your
fireplace manufacturer's instructions for clearance to
combustible requirements.
MANTEL
SURROUNDS AND
MANTEL SHELF
COMBO UNIT
HWFMC-72UH-1
SURROUNDS
HWFMS-48(UO,W)-1
MANTELSHELVES
HWMS-60(UO,W)-1
HWMS-72(UO,W)-1
Mantel Modification Instructions
1. When modifying the surround (HWFMS48(UO,W)) to match
the HWMS60(UO,W) mantelshelves, the cuts shown in
Figure 1 give the best appearance. No modification is
necessary for the HWFMC72.
12"
12"
Note:
Top and side trim will need to be cut to fit these modifi-
cations.
12"
Figure 1
Page 1

Advertisement

loading

Summary of Contents for HouseWarmer HWFMC-72UH-1

  • Page 1: Installation Instructions

    INSTALLATION INSTRUCTIONS MANTEL SURROUNDS AND MANTEL SHELF COMBO UNIT HWFMC-72UH-1 SURROUNDS HWFMS-48(UO,W)-1 MANTELSHELVES HWMS-60(UO,W)-1 HWMS-72(UO,W)-1 INSTRUCTIONS MUST BE LEFT WITH OWNER FOR FUTURE REFERENCE AFTER INSTALLATION. Mantel Modification Instructions Recommended for use with most fireplaces from 32 to 1. When modifying the surround (HWFMS48(UO,W)) to match 42 inches wide and up to 38 inches tall.
  • Page 2 Mantel Installation Instructions 3. Attach the surround assembly to the wall cleat using two Align and attach the breast board to the right and left side finishing nails through the breast board. See Figure 4. assemblies. See Figure 2. Breast board ends should be flat against the inside edges of the side assemblies and flush at the top of the side assemblies.
  • Page 3 Center and attach the 42” wall cleat 4-5/8” above the sur- round using two 1-1/4” drywall screws. See Figure 7. UPPER WALL CLEAT 4-5/8” Figure 7 Align and attach the mantelshelf to wall cleat using two finishing nails. If mounting HWMS(60,72)(UO,W) only, see the firebox manufacturer’s instructions for clearance to combustible requirements.
  • Page 4 M10582 Trim Set Quantity Included Hardware included in packs M10536 M10603 1-1/4” Screw Finishing Nail HOUSEWARMER is a registered trademark of Empire Comfort Systems Inc. www.housewarmerproducts.com Manufactured by: EMPIRE EMPIRE Empire Comfort Systems Inc. 918 Freeburg Ave. Belleville, IL 62220...

This manual is also suitable for:

Hwfms-48uo-1Hwfms-48-1Hwms-60uo-1Hwms-60w-1Hwms-60-1Hwfms-48w-1 ... Show all