EarthWay C25HD Assembly And Operating Instructions

P C
LEASE ALL IF YOU ARE MISSING ANY PARTS
THE SAFE OPERATION OF THIS SPREADER
S H L : 574-848-7491 or 800-294-0671 E
UPPORT OT INE
HELPFUL HINTS:

If your spreader does not spread evenly, be sure the FRONT on the gear box toward the tow hitch. The impeller must turn clock-
wise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer
stuck on the impeller blades will cause uneven spreading.

Your spreader is designed to be towed at three miles per hour—maximum. Slower or faster speeds will change the spread patterns.
Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each use. Wash be-
tween the shut off plate and bottom of the hopper.

Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
Your new spreader has been shipped semi-assembled
resulting in easy assembly and a short time before it is
ready for use. Fig 1
Assembly
Step 1: Remove your spreader from the shipping carton
Fig 2.
Step 2: Remove the 2 bolts that are in the frame Fig 3.
and then lift the tongue into position to allow
the bolts just removed to go through the frame
and the tongue as shown in Fig 4.
Step 3: Tighten the 2 bolts in Fig 5, then tighten all
other frame bolts as seen in Fig 6.
,
HAVE ANY DIFFICULTY IN ASSEMBLY
. T
HIS MODEL INCLUDES LIFETIME TECHNICAL SUPPORT
READ THE DIRECTIONS BEFORE ASSEMBLY
ASSEMBLY and OPERATING INSTRUCTIONS
EarthWay
for
C25HD & C25HDS
Tow Broadcast Spreaders
: support@earthway.com
MAIL
®
E -N-S
V PRED
rev 10-07
,
OR HAVE ANY QUESTIONS REGARDING
.
Pt. #52155