SlamPak
I n s t a l l a t I o n G u I d e
for the
SLPK-CAN-SPYDER1
sKu#94491& 94490
Thank you for choosing a JL Audio Slampak
installation, your new vehicle-specific enclosed sound system will deliver years of listening pleasure.
We strongly recommend that you have your new Slampak
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
®
for your motorcycle sound system. With proper
®
installed by your authorized JL Audio
If you choose to perform the installation yourself, it is absolutely vital that
the Stealthbox
®
be properly mounted to the vehicle according to these
instructions. Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
SLPK-CAN-SPYDER1_INSTR_SKU# 011312
InstallatIon
d I F F I C u l t Y :
3
estImated tIme:
1 HouR
s t e P 1
Empty out the front storage space of the motorcycle so that
you have a clean area to work in.
If you are only installing the pods, skip to steP 16.
s t e P 2
Remove the bottom panel above the rear tire as show here
s t e P 3
Lift the seat, remove the panel that simulates a gas tank at
the top center of the motorcycle. Remove the two panels
labelled "can-am" (one on each side of the motorcycle) and
the two panels labelled "spyder" (one on each side of the
motorcycle).
Continued on Next Page
out
oF
5