JL Audio Slampak SB-POL-RGRRZR Installation Manual

Slampak
I n s t a l l a t I o n G u I d e
for the
SB-POL-RGRRZR
sKu#94456
2009+
Thank you for choosing a JL Audio Slampak ®
proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening
pleasure.
We strongly recommend that you have your new Slampak
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
for your side by side sport utility sound system. With
® installed by your authorized JL Audio
If you choose to perform the installation yourself, it is absolutely vital that the
Slampak ® be properly mounted to the vehicle according to these instructions.
Failure to mount the enclosure properly presents two problems:
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
SB-POL-RGRRZR INSTR_SKU# 94456
InstallatIon
d I F F I C u l t Y :
2
estImated tIme:
1-2 HouRs
s t e P 1
Unpack the Slampak® mount the two brackets as shown
s t e P 2
There are two each of the pictured clamps, the ones with
the short spacers (un-assembeled in the bag) go directly
in front of the speakers, the ones with the long spacers
(assembeled on the right) are installed from below, there are
also locking pins that are not shown that are available and,
can be put in place through the clamps to keep them in the
locked positions. Make sure that all of the hardware on each
of the clamps is snug so that when the arm is pushed flat,
the rubber section of the clamp is squeezed and expands to
hold the clamp in place.
s t e P 3
Line up the brackets with the existing holes as shown in the
pictures at left and below.
Continued on Next Page
out
oF
5