Advertisement
Quick Links
These instructions are intended for use only by experienced professionals in the automotive
customizing business. Special tools and equipment, as well as specialized handling and care
of product during installation, may be required. Before beginning this installation, carefully read
through the following instructions. Use extreme care when cutting headliner material.
Check for wiring or other componentry above headliner material. Cut only where indicated.
Materials/ Tools required for this installation:
1. #2 Phillips screwdriver
3. 1/4" hex socket bit
5. 10 mm deep socket
7. Audiovox VCP (AVP-7180 or equiv.)
MATERIALS PROVIDED FOR INSTALLATION:
INSTALLATION INSTRUCTION # 44-0033A
INSTALLATION INSTRUCTIONS
50-0283x-017 SERIES 1181323
50-0283x-018 SERIES 1181328
50-0283x-019 SERIES 1181325
JEEP GRAND CHEROKEE
VIDEO CASSETTE PLAYER HOUSING
2. Powered screwdriver or drill with adapter
4. Razor knife or similar
6. Pin router or similar
FOR
June 7, 1999
Printed in the U.S.A
Advertisement
Related Manuals for Jeep 50-0283x-017 SERIES
Summary of Contents for Jeep 50-0283x-017 SERIES
- Page 1 5. 10 mm deep socket 7. Audiovox VCP (AVP-7180 or equiv.) MATERIALS PROVIDED FOR INSTALLATION: INSTALLATION INSTRUCTION # 44-0033A INSTALLATION INSTRUCTIONS 50-0283x-017 SERIES 1181323 50-0283x-018 SERIES 1181328 50-0283x-019 SERIES 1181325 JEEP GRAND CHEROKEE VIDEO CASSETTE PLAYER HOUSING 2. Powered screwdriver or drill with adapter 4.
- Page 2 ITEM Description SCREW, # 8 X 3/4" PPH WELL NUT, 10-32 SCREW, 10-32 x 1" PPH WASHER, # 10 SCREW, # 10 X 1/2" HWH SCREW, # 8 X 9/16" PWH CD/VCP MOUNTING BRACKET HOUSING MOUNTING BRKT. HOUSING TOP STORAGE POCKET HOUSING BOTTOM INSTALLATION INSTRUCTION # 44-0033A I.
- Page 3 IF VECHICLE IS NOT EQUIPPED WITH A FACTORY 10 DISC CD CHANGER, PROCEED TO STEP 5. FIGURE 1 2. Disconnect wiring from CD changer. See Figure 2. 3. Using a 10mm deep socket, remove and retain (4) four 6mm nuts which secure bracket to vehicle.
- Page 4 5. Locate the O.E.M. storage pocket mounted to the rear passenger side of vehicle. Remove and discard pocket by moving it upward and outward. See figure 4. FIGURE 5 7. Install (2) two housing mounting brackets (item 8 pg 2) as shown and secure using (3) three # 8 X 9/16"...
- Page 5 8. Route video and audio cables to rear passenger side VCP location. See Figure 7. II. PREPARATION OF COMPONENTS FOR INSTALLATION FIGURE 8 10. Remove and discard (4) four screws from VCP. Loosely install (4) four #8 X 3/4” screws (item 1 pg. 2) in those locations.
- Page 6 13. Align top holes in VCP mounting bracket (item 7 pg 2) with holes in vehicle. See Figure 11. 14. Insert (2) two well nuts (item 2 pg 2) into top holes and secure using (2) 10-32 x 1" screws (item 3 pg 2) and (2) two # 10 washers (item 4 pg 2).