Page 2
Cables for Gateway 20 through 21 File Name: Revision Date: Revision Level: FCC Notice Warning: This equipment generates, uses, and can radiate radio frequency energy; and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment.
Page 4
Cables for Gateway 20 through 21 9F to 9M/F (DCE) This table lists the required RS-232 wiring required to provide a DCE interface for a Gateway Comm. Port. The pins should be connected from one connector to the other using the transpositions indicated. This cable is used for modem emulation. Units Supported •...
Page 5
Cables for Gateway 20 through 21 25F to 25F Gender Changer This is used to change a 9-pin male end connector to female. Units Supported • C20 JBM Electronics Part Number: C/9FF-XGENDER 25F to 25F Gender Changer This is used to change a 25-pin male end connector to female. Units Supported •...
Page 6
Cables for Gateway 20 through 21 RJ-45 Straight This table lists the Ethernet pins used in the Ethernet Port ETH0. For a straight-wired connection the pins should be connected from one connector to the other without transpositions or other wiring changes. Units Supported •...
Page 7
Cables for Gateway 20 through 21 RJ-11 Straight This table lists the required pins used in the Modem cable used to connect the Gateways to an asynchronous modem. Pins should be connected from one RJ-11 connector to the other without transpositions or other wiring changes. Units Supported •...