Advertisement
Quick Links
Advertisement
Summary of Contents for JBM electronics C20 through C21
- Page 1 Cables C20 through C21...
- Page 2 Cables for Gateway 20 through 21 File Name: Revision Date: Revision Level: FCC Notice Warning: This equipment generates, uses, and can radiate radio frequency energy; and if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class A computing device pursuant to Subpart J of part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment.
-
Page 3: Cable Description
Cables for Gateway 20 through 21 Port Serial DE-9M RS232 DTE async (Comport) RJ-45 Ethernet Modem RJ-11 Dial-Tone async © JBM Electronics Co. C20 –C21 Cable Description 9F to 9M DCE Cable 6foot 9F to 25M DCE Cable 6foot 9F to 9F Straight Gender Changer 25F to 25F Straight Gender Changer RJ-45 Straight RJ-45 Crossed... - Page 4 Cables for Gateway 20 through 21 9F to 9M/F (DCE) This table lists the required RS-232 wiring required to provide a DCE interface for a Gateway Comm. Port. The pins should be connected from one connector to the other using the transpositions indicated. This cable is used for modem emulation. Units Supported •...
- Page 5 Cables for Gateway 20 through 21 25F to 25F Gender Changer This is used to change a 9-pin male end connector to female. Units Supported • C20 JBM Electronics Part Number: C/9FF-XGENDER 25F to 25F Gender Changer This is used to change a 25-pin male end connector to female. Units Supported •...
- Page 6 Cables for Gateway 20 through 21 RJ-45 Straight This table lists the Ethernet pins used in the Ethernet Port ETH0. For a straight-wired connection the pins should be connected from one connector to the other without transpositions or other wiring changes. Units Supported •...
- Page 7 Cables for Gateway 20 through 21 RJ-11 Straight This table lists the required pins used in the Modem cable used to connect the Gateways to an asynchronous modem. Pins should be connected from one RJ-11 connector to the other without transpositions or other wiring changes. Units Supported •...