Casio 5106 Operation Manual

MA0907-EA
Operation Guide 5106/5119/5136
• Your watch may differ somewhat from the one shown in the illustration.
Stopwatch minute
Hour hand
Second hand
Stopwatch second hand
To set the time
1. Pull the crown out when the second hand is at 12 o'clock position and the second
hand stops.
2. Set the hands by rotating the crown. Rotate the crown to move the hands. Move the
minute hand four or five minutes past the time you want to set, and then back it up
to the proper setting.
3. Push the crown back in to the normal position.
Using the Stopwatch
The stopwatch lets you measure elapsed time up to 29 minutes, 59 seconds.
To measure times with the stopwatch
Elapsed Time
Start Stop
To adjust the position of the stopwatch second hand
1. Press B to reset the stopwatch, and check the alignment of the stopwatch minute
hand and second hand.
2. Pull out the crown.
3. Press A to move the stopwatch second hand forward until it points to the
12 o'clock position.
4. Push the crown back in to its normal position.
I For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the
minute hand.
After certain amount of time elapsed, read the graduation on
the elapsed time bezel which the minute hand points to.
The elapsed time is indicated.
• Some water resistant models are equipped with a screw lock
crown.
• With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
• Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
Accuracy at normal temperature: ± 20 seconds a month
Display: 3 analog hands (timekeeping hour, minutes, and seconds),
3 dials (Stopwatch seconds, stopwatch minutes, and timekeeping 24-hour)
Stopwatch function: Measuring capacity: 29'59''/Measuring unit: 1 second
Measuring mode: Elapsed time
Battery: One silver oxide battery (Type: SR621SW)
Approximately 2 years on type SR621SW (assuming one stopwatch operation 30 min./day)
Stopwatch minute
Hour hand
Minute hand
24-hour
Setting time
Crown
(Normal position)
Second hand
Stopwatch second hand
Modules: 5106/5136
Stopwatch minute hand
Hour hand
Minute hand
24-hour hand
Setting time
Crown
(Normal position)
Second hand
Stopwatch second hand
Module: 5119
Re-start Stop
mark with the
Elapsed time bezel
Specifications
Minute hand
24-hour
Setting time
Crown
(Normal position)
Clear
1