Related Manuals for Olson Technology EDFA
Summary of Contents for Olson Technology EDFA
- Page 1 OTEB-CO-B Series Booster EDFA OPERATING MANUAL 24926 Highway 108 Sierra Village, CA 95346 Phone: (800) 545-1022 Fax: (209 586-1022 025-000533 Rev X6 E-Mail: sales@olsontech.com 27 Apr 2010...
-
Page 2: Table Of Contents
Safety Precautions ...................................3 High Voltage ....................................3 Shock Hazard...................................3 INTRODUCTION..................................4 Figure 1 -Block Diagram of OTEB-CO-B Series EDFA ................. 4 GENERAL FEATURES................................5 PANEL LAYOUTS ..................................5 Figure 2 - EDFA Front Panel Layout ....................... 5 Figure 3 - EDFA Rear Panel Layout ........................ 5 Technical Specifications................................6... -
Page 3: Safety
NEVER look into or use any optical instrument to view the distant end of a fiber that may be connected directly or via an optical splitter, to a transmitter or EDFA that may be operating. This specifically applies to fibers that are to be connected to receivers (such as the OTPN-1000) or other devices at any distance from the laser transmitter or EDFA. -
Page 4: Introduction
1550nm wavelength band (1540-1560nm typically). It is made of high quality optical components, and carefully designed to maximize overall performance. Low power EDFA’s may only have a single pump, while high power units can have up to three pumps. -
Page 5: General Features
GENERAL FEATURES The Olson Technology Model OTEB-CO-BYXX EDFA incorporates a reliable optical output drive circuit, and laser TEC to pro- vide a highly reliable Erbium-doped optical amplifier. Built-in microprocessor software allows the unit to monitor a number of sys- tem parameters, including: laser status, system alarms, network management, Thermoelectric Cooler (TEC) circuit operation, etc. If a failure is detected, the power supply for the laser will shut down automatically, a red LED indicator will light, and the front panel display will show the nature of the problem. -
Page 6: Technical Specifications
Technical Specifications Typical Models* Number of Outputs Fixed Output Power (dBm) Power Range (dB) -10 to +10 Input Max Alarm (dBm) Power Min Alarm (dBm) Wavelength (nm) 1540 to 1560 ±0.3 Output Stability (dB) ≤4.5 ≤5.0 ≤5.3 Noise 0dBm Input (dB) Figure ≤5.5 ≤6.0... -
Page 7: Status Display Panel Operation
+5V Voltage: +5V READS… => ±0.5V alarm -5V Voltage: -5V READS… => ±0.5V alarm Serial Number Displays the serial number of the EDFA. IP Address for RS-232 Connector The IP address code can be set by the operator via the RS-232 connector on the rear panel. -
Page 8: Description Of Status Alarm
DESCRIPTION OF STATUS ALARM The front panel indicator LED indicator may be red, green, or off. When the LED is green the EDFA is operating properly. When the LED is off, the unit is off. A red LED indicates an alarm condition. The alarm condition will be displayed on the display panel.