Fusion CS-FR4020 Quick Manual

FULL RANGE SPEAKERS
CS-FR4020 CS-FR5020
SPEAKER PARAMETERS
Peak Power (Watts)
Rated Power (Watts)
Frequency Response
Impedance
Sensitivity
Cone Material
Tweeter
Mounting Depth
Mounting Diameter
WARNING: Do not drill mounting holes with speaker in place as this could allow drill shavings to damage the
voice coil and void your warranty.
CS-FR6020 CS-FR6930
CS-FR4020 CS-FR5020
160 190
30 35
44Hz - 24kHz 41Hz -24kHz
4 Ohms 4 Ohms
83dB 84dB
Polypropylene Polypropylene
PEI PEI
45mm (1-3/4") 43mm (1-11/16")
103mm 118mm
(4-1/16") (4-21/32")
INSTALLATION GUIDELINES
Ensure the audio system is turned off before making any connections to the
amplifier, speakers or source unit. Failure to do so could result in permanent
damage to the audio system.
When wiring the speakers ensure that the wire is protected from sharp
objects and always use rubber grommets when wiring through metal panels.
Ensure all terminals and connections are protected from the vehicle chassis
and from each other as failure to do so could result in permanent damage to
the audio system.
When connecting the source unit and speakers ensure you connect the
positive and negative output wire from the source unit to the corresponding
speaker terminals. This will ensure the audio system will be in phase.
1) Ensure there is adequate clearance and depth for the speaker to be
mounted.
2) Use the supplied template to mark out & cut the correct diameter hole.
3) Drill four holes for the mounting screws.
4) Seperate the grille from the frame.
5) Insert the speaker and grille frame and affix with the screws provided.
6) Complete installation by replacing the grille into the grille frame.
CS-FR6020 CS-FR6930
210 310
40 55
35Hz -24kHz 28Hz -25kHz
4 Ohms 4 Ohms
85dB 87dB
Polypropylene Polypropylene
PEI PEI
41.5mm (1-11/16") 71.5mm (2-14/16")
126mm 222 x 156mm
(5") (8-24/32 x 6-3/16")
www.fusionelectronics.com