Switching-Outputs - beier USM-RC-2 Operating Manual

D

Switching-outputs

The sound module has 12 outputs, which can be used to drive electrical consumer
units such as lamps, light-emitting diodes, relays etc. Different switching functions
can be attached to the 12 outputs by using the Sound-Teacher. (see page 67).
The outputs 11 and 12 are internally connected in parallel to both servo outputs of
the sound module. If the servo outputs are activated in the sound teacher, it is not
allowed to connect anything to the corresponding switching output!
The sound module is always switching the negative pole to each output and thus to
the connected load (e.g. LED, lamp, relay). The positive pole is always connected
permanently to the load.
The intensity (PWM-control) of each output can be configured with the Sound-
Teacher by steps of 5%, between 5% and 100%.
Following functions are possible:
 output static on
 output flashing
 output as pulse
 output flickering (sound dependend)
 daytime running light
 parking light
 low beam headlight
 high beam headlight
 front fog light
 rear fog light
 brake light
 reversing light
 indicator left
 indicator right
 bending light left
 bending light right
 combined headlight
 combined rear light
 in motion on
 in stationary on
 at accelerating on
 at driving speed on
 output sequence 1
 output sequence 2
 Ship: All-round light red top
 Ship: All-round light red middle
 Ship: All-round light red bottom
 Ship: All-round light green top
 Ship: All-round light white middle
 Ship: All-round light white botom
 Ship: 1. Masthead light
03.02.2014 BEIER-Electronic
Sound module USM-RC-2
41