Adjusting The Engine Sound To The Driving Speed - beier USM-RC-2 Operating Manual

D Sound module USM-RC-2
Using the EKMFA-mode on proportional channel #3 (X2/3) to switch on engine
sound:
With the One-channel multi-function selection (EKMFA) you can nearly control the
whole sound module with only one free channel of the transmitter. "Counting" (and
pressing the joystick a corresponding number of times) is used to determine, which
function is triggered. In the Sound-Teacher you can set up, how often the joystick
must be pressed, to turn on/off the engine sound.
This possibility is only available in digital- or mix mode.
Turn on engine sound automatically by motion:
Is this option activated, the engine sound is switched on automatically, as soon as
you accelerate the first time (that means for example moving the joystick out of the
neutral position). The engine sound keeps switched on as long as you are driving. If
the model is stopped, the engine sound will be turned of after an adjustable time (e.g.
10 seconds). If you start driving again, the sound will be switched on again. This
method has the advantage, that no additional channels (or switching units) in the
transmitter are needed to activate the engine sound.

Adjusting the engine sound to the driving speed

With the trimmer P1 the speed of the driving sound can be adjusted. However, in
case you more than one driving sound (FG1-FG5) we recommend setting this
trimmer to the middle and adjusting the speed of the driving sound by the driving
sound diagram (see page 77).
03.02.2014 BEIER-Electronic 29