M-00 Owners Manual Serial Number: Copyright 2001, NHTPro, a Recoton Corporation Brand NHTPro 527 Stone Rd. Benicia, Ca 94510 ph: (707)748-5940 fx: (707)748-5945 www.nhtpro.com...
Page 2
Safety Instructions – Please Read First CAUTION: To reduce the risk of electrical shock, do not remove the cover. No user serviceable parts are inside; refer for servicing to qualified personnel. WARNING: To reduce risk of fire or electric shock do not expose this appliance to rain or moisture.
The M-00 can accept virtually any "line level" signal via the XLR, TRS, or Phono connectors located on the rear panel. There is no mixer in the M-00, and only one source should be physically connected to the speaker at any time.
When this switch is set to “On”, the Auto Power circuit senses the incoming signal and activates the internal amplifier, eliminating the need to turn the M-00 on and off manually. If no input signal is present for approximately 10 minutes, the amplifier goes into a low-power standby mode until an input signal is received.
Page 5
For appropriate commercial uses, as many as 10 M-00's per channel can be daisy-chained by alternately utilizing the bridged XLR and the TRS jacks. The exact number of M-00's that can be daisy-chained together depends on the low impedance drive capability of the mixer or distribution amplifier. Please refer to the table in Fig.
Except for the occasional flattering comment, your M-00's need no regular maintenance. Never attempt to clean the M-00's driver units except for very light feather dusting. The M-00 cabinet can be cleaned using a moist soft cotton cloth. Avoid silicone or oil-based cleaners or treatments.